_GDIPlus_PenGetEndCap
Gets the pen end cap
#include <GDIPlus.au3>
_GDIPlus_PenGetEndCap($hPen)
Параметры
$hPen | Дескриптор объекта Карандаш |
Возвращаемое значение
Успех: | End cap type: |
$GDIP_LINECAPFLAT - Specifies a flat cap | |
$GDIP_LINECAPSQUARE - Specifies a square cap | |
$GDIP_LINECAPROUND - Specifies a circular cap | |
$GDIP_LINECAPTRIANGLE - Specifies a triangular cap | |
$GDIP_LINECAPNOANCHOR - Specifies that the line ends are not anchored | |
$GDIP_LINECAPSQUAREANCHOR - Specifies that the line ends are anchored with a square | |
$GDIP_LINECAPROUNDANCHOR - Specifies that the line ends are anchored with a circle | |
$GDIP_LINECAPDIAMONDANCHOR - Specifies that the line ends are anchored with a diamond | |
$GDIP_LINECAPARROWANCHOR - Specifies that the line ends are anchored with arrowheads | |
$GDIP_LINECAPCUSTOM - Specifies that the line ends are made from a CustomLineCap | |
Ошибка: | Возвращает -1 и устанавливает @error |
См. также
_GDIPlus_PenSetEndCapСм. также
Искать GdipGetPenEndCap в библиотеке MSDNПример
#include <GUIConstantsEx.au3>
#include <GDIPlus.au3>
_Main()
Func _Main()
Local $hGUI, $hGraphic, $hPen
; Создаёт GUI
$hGUI = GUICreate("GDI+", 400, 300)
GUISetState()
; Создаёт ресурсы
_GDIPlus_Startup ()
$hGraphic = _GDIPlus_GraphicsCreateFromHWND ($hGUI)
$hPen = _GDIPlus_PenCreate (0xFF000000, 8)
_GDIPlus_PenSetEndCap($hPen, $GDIP_LINECAPARROWANCHOR)
; Show pen end cap
MsgBox(4096, "Информация", "Pen end cap type: " & _GDIPlus_PenGetEndCap ($hPen))
; Рисует стрелки
_GDIPlus_GraphicsDrawLine ($hGraphic, 10, 130, 390, 130, $hPen)
_GDIPlus_PenSetWidth($hPen, 6)
_GDIPlus_GraphicsDrawLine ($hGraphic, 10, 150, 390, 150, $hPen)
_GDIPlus_PenSetWidth($hPen, 8)
_GDIPlus_GraphicsDrawLine ($hGraphic, 10, 170, 390, 170, $hPen)
; Цикл выполняется, пока окно не будет закрыто
Do
Until GUIGetMsg() = $GUI_EVENT_CLOSE
; Очищает ресурсы
_GDIPlus_PenDispose ($hPen)
_GDIPlus_GraphicsDispose ($hGraphic)
_GDIPlus_ShutDown ()
EndFunc ;==>_Main